This Warranty Does not include the following: A site inspection performed on a 36-month cycle.This warranty is valid throughout the life of the product in conjunction with the following requirements: You may have other statutory rights that vary from state to state or from province to province, in which case this limited lifetime warranty does not affect such statutory rights. This limited lifetime warranty gives you specific legal rights. Subzero Engineering warrants all labor performed and material installed at the aforementioned job site and that it will at its sole option, repair or replace this product or any part of this product if it confirms that the product is defective in materials or workmanship under normal use and maintenance. But likely to get such bad scratches would want to change?) Worth it to do flush inset? Any photos of standard versus flush inset (not Subzero stock photos), but in actual homes would be helpful.DATA CENTER CONTAINMENT | ELITE SERIES PRODUCTS Limited Lifetime WarrantyĮffective on all Essential Plus+ (Elite Series) products purchased since December 19, 2019. (It is somewhat appealing in case the stainless gets scratched, we would have that option, whereas with the standard install, couldn't replace the stainless panels because part of the unit. Also, if later we want to put on cabinet panels instead, I suppose we could swap the stainless panels for cabinet panels (is that possible?), though not sure we would actually do it. Worth it for flush inset? Kind of a cleaner, more custom look. For the flush inset install, would have to get the fridge/freezer panel ready and then separately get stainless steel fridge and freezer panels and louvered grill. The reason is for the proud/standard install, we would just get it as a fridge/freezer with the stainless panels and professional handles included. It seems kind of silly for the same product. It would be about $820 more to do the flush inset install. We are deciding whether to get a proud/standard install, or do a flush inset install. We are looking to get a 48 inch built-in Subzero fridge/freezer with stainless front and professional handles (likely no external or internal dispenser).

Sub zero fridge installation